movilTopo STL Back to movilTopo

Surveying station for a 2 m, 30 mm wooden pole

Download the STL parts and follow the guide to assemble a 2 metre, 30 mm diameter wooden surveying pole with a GNSS mount.

Required materials (2 m x 30 mm pole)

A 2 m wooden pole with a 30 mm diameter.
3D printed parts (downloads below).
GNSS receiver: UM980 with its enclosure, or an equivalent setup.
GNSS antenna and cables suited to your receiver.
An Android phone with USB OTG for movilTopo.
Screws or clamps suited to the actual pole diameter.

Recommended minimum setup: macho.stl + hembra.stl + apriete.stl + nivel.stl + antena.stl. For UM980, add its enclosure and dedicated clamp.

Quick assembly guide

Print the base parts and check the fit on the 2 m, 30 mm wooden pole.
Assemble the pole joint using the macho and hembra parts.
Secure the assembly with apriete and add the nivel spirit level.
Mount the antenna support and GNSS receiver (UM980 where applicable).
Check vertical alignment, rigidity and cable routing before fieldwork.

View movilTopo on Google Play

Download STL files

antena.stlDownload

apriete.stlDownload

apriete_hembra.stlDownload

apriete_telefono.stlDownload

apriete_um980.stlDownload

hembra.stlDownload

macho.stlDownload

nivel.stlDownload

um980-case-d.stlDownload

um980-case-u.stlDownload

Reference photos

Field setup: STL parts and GNSS station assembly — Field setup

View 1: STL parts and GNSS station assembly — View 1

View 2: STL parts and GNSS station assembly — View 2

View 3: STL parts and GNSS station assembly — View 3

View 4: STL parts and GNSS station assembly — View 4

View 5: STL parts and GNSS station assembly — View 5